Out of Stock
Samsung Leds provide 360 degree illumination.
Water and Dust proof: IP68
30,000 hour expected life
1 year warranty
5500K Color Temperature -Cool White
Dual intensity - Tail Light and brake light circuits
7 watts tail light - 8 watts with brake light
Posted by Robert on 17th Aug 2017
I have a 2008 Can Am Spyder GS and wanted a good quality LED Bulb.... Ordered and received (quickly) and installed them into my bike. The fir was perfect and they worked immediately. Started the bike and discovered that due to the low wattage of these bulbs, the computer put my bike into limp home mode as it could not detect any brake/tail lights. Had to remove them and briefly considered ordering load resistors, however the resistors get very hot and I don't want to play around with them. I need a plug and play LED bulb with built in resistors.
Posted by Jim on 31st May 2017
I've tried a few different LED 1157's and none compare to this one for brightness as both a tail light and a stop light. Others either didn't show a brightness shift or were way dimmer than an incandescent. It also has the LED's at the right spots for a motorcycle tail light: both the end and the sides for the reflector. Doing this with the headlight is great for increasing your available electrical power and increases your visibility. Win -Win!!
Posted by CyberWes on 13th Mar 2017
The tail light circuit is MUCH brighter than stock. The relative increase in the brake light is not as dramatic as I had hoped. Still it’s nice to have a REALLY bright tail light.
Posted by Bimmer on 4th Jan 2017
Posted by Todd on 24th Aug 2015
The LED bulbs showed up today (thanks for the quick service!) and I promptly installed them.
The tail light was a no brainer and is much brighter!
I'm very pleased with my purchase and this is the best $70 I've spent on the 'ol gal without a doubt.
Besides the obvious and most important safety reasons, the power consumption reduction will help out too as I'm about to install some heated grips.
Posted by eleuthero on 17th May 2015
Taillight is MUCH brighter than the stock 1157 incandescent. The stoplight is noticeably brighter too. Easy install. I had some dielectric grease in socket with the incandescent bulb, be advised this should be cleaned out when putting in this LED. I had noticed the stoplight only flickered until I cleaned out any of the grease.