Model 19 LED light kit
Includes 2 Model 19 LED lights and wiring harness. Everything you need to install the lights on a stud or flat surface.
- Cree LED - XLamp XM-L2 LED.
- Stainless steel hardware
- AR-1 coated Polycarbonate lens
- IP68 rated - Dust, shock and waterproof.
- Powder coated cast AL housin
- Oring and grommet sealed housing
- Input voltage 5-30VDC (This light will function on 6v systems)
- Power consumption - .8a at 12vdc
- 1100 Lumens per light
- 5700k color temperature
- Full beam, no upper cutoff.
- Optics - Deep draw reflector
- Beam Pattern - 10 degree spot center beam with spill/fill outside the main beam. This gives a combination effect of both a spot and a flood. The spill/fill outside the main beam is adequate to navigate by but by no means is it blinding.
- Lens color - White or Amber
- Plug n play harness, no soldering or crimping required
- On/Off switch
- 18 gauge wire
- Fuse holder
- ATC fuse
- Battery ring terminals
- Adequate wire length for most any installation
Download Installation Instructions