The M60 light kit includes everything you need to install a pair of lights to your choice of mounting location.
Two (2) Model 60 Off Road Led lights with standard bracket.
Plug n Play Wiring harness with waterproof switch.
Light controller / dimmer
Heavy duty light bracket
Xpel lens protection
Handlebar mounted or waterproof switch
About the Model 60
LED type: 4 Cree XML-U2 leds
Reflector: 4x shallow draw, AL deposition
Housing: Machined aluminum, black powder coat, openings sealed with orings to insure waterproofness.
Mount: Stainless steel with a wide range of vertical adjustment. The mount locks in place with stainless hardware including nyloc nut. 6mm bolt hole provides a secure mount to your choice of mounting locations. 25mm/1” square mount foot will mount to any flat location or stud. Includes stainless hardware to connect light to your mount.
Size: length 70mm , diameter 55mm
Weight:Approximately 8 oz. per light depending on options chosen.
Light Performance (single light)
Beam (degrees): 30 degree primary beam provides nice width with adequate distance.
Light output (lumens): 3600
Color Temperature (kelvin): 5500
Usable Light (feet/meters): 600'/183m, Spot that deer, dog, animal/obstacle!
Power Usage: 2.4amps @12vdc or 28 watts, much reduced draw with a dimmer.
About the wiring harness
Plug n Play: No soldering, crimping or other wire prep required. When purchased with a dimmer, the dimmer will be integrated into the harness. Please leave a note during checkout where you prefer the dimmer be located.
Light Wiring: One meter wire lead with connector. Sheathed lead provides resistance to rubs, scraps and other potential damage while maintaining waterproofness. Adequate length for mounting on lower fork.
LED Control /Dimmer(optional): When purchased with a dimmer, the dimmer will be integrated into the harness. Please leave a note during checkout where you prefer the dimmer be located. The EZcan location is fixed (under seat) by the stock wiring, we extend the light leads and install amp connectors to plug into the EZcan. The rotary dimmer is typically installed towards the front of the bike on dash or handlebar. The wireless dimmer is typically installed under seat or in a fairing, very flexible installation due to the wireless nature. The bluetooth dimmer is typically installed under seat or in a fairing.
Custom: We can customize the wire lengths to meet your needs. Typically there will be adequate wire, with length to spare.
Switch: Waterproof push button on/off switch. Switch can be panel mounted (3/8" hole) or surface mounted with velcro or double sided tape.
1 year from date of purchase to customer of record.
Check our store policies page for detailed information.